FRAME GP-TELESCOPING RECOIL 3370984 - Caterpillar

3370984 FRAME GP-TELESCOPING RECOIL Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3370984
337-0984
3370984

Caterpillar 3370984 FRAME GP-TELESCOPING RECOIL

Buy FRAME GP-TELESCOPING RECOIL 3370984 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 8

Caterpillar 3370984 Parts scheme FRAME GP-TELESCOPING RECOIL

For full view, you need register

Information:

Replace the Pilot Filter
Illustration 1 g00101497
Open the access door on the right side of the machine.
Illustration 2 g00101499
Clean the area in order to keep dirt out of the filter base.
Remove the used pilot filter element from the filter base.Note: This element is a cartridge type filter. The element cannot be reused.Note: Used filters should always be disposed of according to local regulations.
Clean the filter base.
Illustration 3 g00101502
Coat the seal of a new pilot filter with clean hydraulic oil. Install the new pilot filter in the filter base. Tighten the pilot filter hand tight.
Close the access door.Replace the Case Drain Filter
Illustration 4 g00101504
The case drain filter is located on the side of the fuel tank.
Illustration 5 g00101507
Clean the area in order to keep dirt out of the filter base.
Remove the used case drain filter from the filter base.Note: This element is a cartridge type filter. The element cannot be reused.Note: Used filters should always be disposed of according to local regulations.
Clean the filter base.
Illustration 6 g00101502
Coat the seal of a new case drain filter with clean hydraulic oil. Install the new case drain filter in the filter base. Tighten the case drain filter hand tight.
Drive the machine slowly for 10 to 15 minutes. Move each cylinder evenly through several cycles.
Illustration 7 g00101508
Return the machine to the position that is shown above. Check the machine for oil leaks.
Stop the engine.
Open the access door on the right side of the machine in order to access the sight gauge.
Illustration 8 g00101511
(A) High Temperature Range. (B) Low Temperature Range.
Maintain the oil level in the low temperature range for a cold machine. Maintain the oil level in the high temperature range for a machine that is at a normal operating temperature.
Illustration 9 g00101541
Slowly loosen the filler plug in order to relieve any pressure. Remove the filler plug in order to add oil, if necessary.
Clean the filler plug. Install the filler plug.
Close the access door.