FRAME GP-TELESCOPING RECOIL 3417494 - Caterpillar

Illustration 14 g06288556
( 5G) 381-2621 Cable Tie Mounting
(5M) 7K-1181 Cable Strap
(5J) 4P-7581 Clip
(5K) 4P-8134 Clip
(5T) 8T-4137 Bolt
(5Q) 8T-4121 Hard Washer
(5R) 8T-4133 Nut
(5V) 8T-4182 Bolt
Illustration 15 g06288539
(5B) 419-6122 Chassis Harness As
(5D) 449-2331 Chassis Harness As
(5M) 7K-1181 Cable Strap
(5Q) 8T-4121 Hard Washer
(5T) 8T-4137 Bolt
Route harness assembly (5B) to the beam and the RH fender. Secure harness assembly (5B) and (5D) using bolt (5T), washer (5Q), and cable straps (5M).
Illustration 16 g06288897
(4A) 392-5485 Satellite Receiver Gp
(4D) 6V-7357 Bolt
(4F) 9X-8256 Washer
Install GPS receiver (4A) to the underside of the cab roof on the LH side using four bolts (4D) and four washers (4F).
Illustration 17 g06288917
(4A) 392-5485 Satellite Receiver Gp
(4B) 447-6491 Cab Harness As
(4C) 438-5957 Cable As
Illustration 18 g06288943
(4A) 392-5485 Satellite Receiver Gp
(4C) 438-5957 Cable As
Illustration 19 g06289008
(4C) 438-5957 Cable As
(4E) 7K-1181 Cable Strap
Illustration 20 g06289016
(4C) 438-5957 Cable As
(4E) 7K-1181 Cable Strap
Route harness assembly (4B) and cable assembly (4C) to satellite receiver (4A).
Illustration 21 g06290338
(6A) 472-6229 Bracket
(6B) 372-4806 Antenna
(6C) 344-5675 Nut
(6D) 7K-1181 Cable Strap
(6E) 8T-4121 Hard Washer
(6F) 8T-4195 Bolt
Mount bracket (6A) to the right- hand front ROPS light bracket using two bolts (6F), four washers (6E), and two nuts (6C).
Illustration 22 g06290365
(A) O-Ring
(B) Screw
Mount antenna (6B) to bracket (6A) using four screws (B). Make sure that O-ring (A) is under antenna (6B) when installing.
Attach cable assembly (4C) to the bottom of antenna (6B).Secure cable assembly using cable straps (6D).Enable and Calibrate
Using Cat Electronic Technician (ET) in the configuration screen enable Auto Carry, and if desired, enable AutoRip.
Enabling the above will require factory passwords
As premium features, there are fees associated
Also in the configuration screen, set the RH lift cylinder to Installed.
Using Cat ET, calibrate the lift cylinder position and inclination sensors following the instructions given by the service tool.