FRAME AS 3598737 - Caterpillar

Connect controller pressure sensor cable and control cable to hose machine.
Illustration 14 g03695806
Connect double foot switch, single foot switch, and calipers to back of controller.
Hardware installation is complete. Turn control power on.Software Verification
The software should now be verified for the latest revision and updated if not current.Software updates and instructions for Cat Hose Machines are located at the Dealer Service Tool website: https://dealer.cat.com/dealer-service-tools. The link is named "Crimputer Software" and is located on the front page. The current software revision for each Cat machine will be listed on this page.
Illustration 15 g03695853
To view the current software in the controller, push the oval black button with 'I' that appears on the 'Start Up Screen'. This is the first screen when machine powers up.
Illustration 16 g03695869
Note: The revision shown is as of May 2014, and is for illustration purposes only. Current revision numbers are shown on the website.Log On Controller
Illustration 17 g03718636
Press the "OK" button to open the Log On dialog box.
Illustration 18 g03718697
Touch the screen in the User field and a keyboard will appear. Type in the user name cat. Push return.
Touch the screen in the password field and keyboard will appear. Type in password name cat. Push return.
Log On box will disappear and return to Start Up Screen.
Press the OK button and screen will advance to the Crimputer III Menu screen.Calibration
The final step is to perform the calibration procedure using the calibration mandrel part number 233-8045 that came with the machine. Note: The machine must be calibrated before using.
Illustration 19 g03695919
After verifying correct software revision, and logging onto the controller using cat for both the username and password, press green OK softkey again. Panel will advance to the Crimputer III Menu screen. Press the "Utility" softkey.
Illustration 20 g03696647
Select 'Probe Calibration.'
Illustration 21 g03696687
Install 32mm dies and press 'GO'. From this screen, start the motor and close/open jaws to install dies
Illustration 22 g03696696
Start the motor and close dies on the small end of the mandrel, hold button until machine stops.
Illustration 23 g03696707
Open dies, remove mandrel, and press 'OK'.
Illustration 24 g03696777
Close dies on large end of mandrel, hold button until machine stops.
Illustration 25 g03696839
Calibration Complete screen is displayed showing calibration number. Calibration number should be between .98 and 1.03
Press OK softkey and display returns to the Crimputer III Menu screen. Calibration is complete.Installation is Complete
The controller is now ready to use. Operation is identical to the Crimputer 2 controller with the exception that the ability to skip measurement has been removed as Cat recommends measuring all crimps to insure quality crimps.