FRAME AS 4583079 - Caterpillar

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Inspect the condition of the O-ring seals. Replace the seals, if necessary.
Install the stud that holds the oil filter to the oil filter base. Tighten the stud to a torque of 68 7 N m (50 5 lb ft).
Illustration 1 g00850052
Typical example
Install relief valve plunger (15) and spring (14) into oil filter base.
Place the O-ring seal on cover (12) and install the plug in oil filter base.
Illustration 2 g00849701
Install the following items in oil filter base: oil pump bypass valve (7), spring (8) and O-ring seal (9) .
Install cover (10) and the two bolts with washers that hold the cover in place.
Install O-ring seal (9) and valve (11) in oil filter base.
Install the two bolts with washers that hold valve (11) in place.
Illustration 3 g00849489
Typical example
Install the following items in oil filter base: retainer (4), retainer spring (3), seat of the relief valve spring (2) and spacer (5) .
Install bolt (1) .
Install three O-ring seals (6) in the oil filter base assembly.End By: Install the engine oil filter base.