FRAME AS- 4697627 - Caterpillar

Removal Procedure
Drain the engine oil into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
Illustration 1 g02141944
Remove bolts (1) and (3).
Loosen fitting (4) and remove oil gauge (2).
Illustration 2 g02141932
Remove nuts (5). Remove switch assembly (6). Remove sound suppression cover (7).
Illustration 3 g02141942Note: Do not pry or gouge the sealing surface of the engine oil pan. Use a rubber mallet to tap lightly on the engine oil pan, if necessary.
Remove bolts (8). Remove studs (9). Remove engine oil pan (10) and the gasket. Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A − Loctite 587 −
Illustration 4 g02142246
Tooling (A) should be applied at Locations (X) for a width of 4.00 1.00 mm (0.158 0.040 inch). Apply Tooling (A) to the joints.
Illustration 5 g02141942
Illustration 6 g02142370
Position a new gasket and engine oil pan (10) on the cylinder block.
Install studs (8). Install bolts (9). Install bolts (9).
Illustration 7 g02143244
Top View of Engine
Tightening sequence for the engine oil pan
Tighten studs (8) and tighten bolts (9) in the sequence that is shown in illustration 7.
Illustration 8 g02141932
Install sound suppression cover (7). Install nuts (5). Install switch assembly (6).
Illustration 9 g02141944
Position oil gauge (2) and tighten fitting (4).
Install bolts (1) and (3).
Fill the engine with oil to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil - Change" for the correct filling procedure.