AVSPARE.COM
parts catalog

FRAME AS 5088338 - Caterpillar



5088338 FRAME AS Caterpillar parts FRAME
Rating:
71
Alternative (cross code) number:
CA5088338
508-8338
5088338
Caterpillar 5088338 FRAME AS

Buy FRAME AS 5088338 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 18
 
  For full view, you need register

Information:


Illustration 1 g01321566
Transmission Solenoids are located on the left side of the transmission.
(1) "Transmission solenoid 1 (forward high)"
(2) "Transmission solenoid 2 (forward low)"
(3) "Transmission solenoid 3 (reverse)"
(4) "Transmission solenoid 4 (2nd speed)"
(5) "Transmission solenoid 5 (3rd speed)"
(6) "Transmission solenoid 6 (1st speed)"
(7) "Transmission solenoid 7 (low range)"
(8) "Transmission solenoid 8 (high range)"
Illustration 2 g02362702
Connections of "Transmission Solenoid 7"
This diagnostic code is associated with the "Transmission Solenoid 7". The FMI 05 diagnostic code means that the "Transmission/Chassis ECM" has determined that the current for the solenoid circuit is below normal.Some possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. A failure of the ECM is unlikely. Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE SOLENOID
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire 902-BR(Brown)) to contact 2 (wire 921-WH(White)).
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the CID 1407 FMI 05 diagnostic code. Expected Result:The active diagnostic code changes from an FMI "05" to an FMI "06" diagnostic code when the jumper wire is installed.Results:
YES - The active diagnostic code changes from an FMI "05" diagnostic code to an FMI "06" diagnostic code when the jumper wire is installed. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 1407 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the diagnostic code. The solenoid is not the cause of the problem. Proceed to Test Step 2.Test Step 2. CHECK THE CIRCUIT FOR AN OPEN
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector J1 from the "Transmission/Chassis ECM".
The jumper wire that was installed in the previous test step remains in place.
At the machine harness connector J1 for the "Transmission/Chassis ECM", measure the resistance from the return, contact J1-50 (wire 921-WH(White)), to the energize contact J1-48 (wire 902-BR(Brown)). Expected Result:The resistance measurement

Caterpillar parts catalog:

Caterpillar parts catalog
BD118 & BD121 Side Discharge Buckets BND00001-UP (MACHINE)


Parts frame Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.