FRAME AS-TRACK ROLLER 8E6914 - Caterpillar

Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Open the access panel on the left side of the operator station in front of the transmission oil filter.
Illustration 1 g02240815
Top view
Illustration 2 g01147802
(2) Warm oil
(3) Cold oil
Always measure the oil with the transmission dipstick on the cap. Hot Oil
Illustration 3 g00493905Use the "TRANSMISSION IN NEUTRAL, ENGINE AT LOW IDLE, AND OIL AT OPERATING TEMPERATURE" side of the dipstick (2). Check when the transmission is in NEUTRAL and the engine is running at LOW IDLE. The oil should be at operating temperature. Maintain the oil level between the "OPERATING ZONE" marks. This procedure is the only accurate way to check the oil level.Cold Oil
Illustration 4 g00493912Check the "ENGINE STOPPED COLD OIL" side of dipstick (3) while the engine is stopped. Maintain the oil between the "OPERATING ZONE" marks. This method should be used as reference only.Note: When you are operating the machine on severe slopes, the quantity of oil in the transmission can be increased up to 10 percent. When you are operating with the increased oil quantity, prolonged operation in some machines can cause high transmission oil temperatures. After the work on the severe slopes has been completed, drain the excessive oil quantity from the bevel gear case.
If the oil level on dipstick (2) indicates that oil is needed, remove filler cap (1) and add the oil.
Clean the filler cap and install the filler cap.
Close the access door.