FRAME AS-UPPER 9C0216 - Caterpillar

Starting The Engine
The engine's Electronic Control Module (ECM) will automatically provide the correct amount of fuel in order to start the engine. Do not hold the throttle down while the engine is cranking. If the engine fails to start in 30 seconds, release the starting switch. Allow the starting motor to cool for two minutes before the starting motor is used again.
Excessive ether (starting fluid) can cause piston and ring damage. Use ether for cold weather starting purposes only.
Cold Mode Operation
The ECM will set cold mode when the coolant temperature is below 18 °C (64 °F).Cold mode is activated five seconds after the start of the engine. During cold mode, low idle speed will be increased to 800 rpm. After 60 seconds, the engine speed is reduced to 600 rpm. Engine power will be limited until cold mode is deactivated.Cold mode will be deactivated when the coolant temperature reaches 18 °C (64 °F).Cold mode varies the amount of fuel that is injected for white smoke cleanup. Cold mode also varies the timing for white smoke cleanup. The engine operating temperature is usually reached before the walk-around inspection is completed.After cold mode is completed, the engine should be operated at low speed until normal operating temperature is reached. The engine will reach normal operating temperature faster when the engine is operated at low speed and low power demand.