FRAME AS-ROLLER-RH 9W2229 - Caterpillar

Table 2 lists the default menu items for a Laser AccuGrade system.
Table 2
Setup Menu - Laser Configuration Menu Items    
Menu Item     Description    
Bench     Automatically positions both laser receivers to within
1.5 mm (0.0591 inch) of the center of the laser beam.    
Vertical Setup     Allows the operator to change the operating mode.     Linked independent lift only
Lift
Lift + Cross Slope
Linked lift + lift
Independent lift + lift    
Increment Switch Adjustment (1)     The Increment Switch Adjustment dialog allows you to set the amount that each press of the vertical offset switch increases or decreases the vertical offset and/or the amount by which the target cross slope adjustment will increase or decrease the target cross slope. Refer to Operation and Maintenance Manual, "Increment Switch - Set" for additional information.    
"Lightbar Scale"     The Light Bar Scales dialogs set the vertical and horizontal tolerances that apply to the LEDs on the Light Bars. Refer to Operation and Maintenance Manual, "Light Bar Scale - Set" for additional information.    
Display and Lightbar Brightness     The Display and Light Bar Brightness dialog sets the brightness of the Display and Light Bars. By default the dialog is only available in the "Setup Menu – Configuration". Refer to Operation and Maintenance Manual, "Brightness (Display and Light Bar) - Set" for additional information.    
Calibrate Sensors     Allows the operator calibrate the angle sensors or laser receivers that are install in the AccurGrade System.    
Valve Speed     Allows the operator to adjust the valve speed for the lift valve and the tilt valve.    
Stability     Allows the operator to adjust the stability for the lift valve and the tilt valve based on the speed of the machine.    
Text Items (1)     Text Items allows you to customize the text items on the Display in order to suit your requirements. Refer to Operation and Maintenance Manual, "Text Items - Set" for additional information.    
Beeper (1)     The beeper can be configured in order to provide an audible signal when various events occur. Refer to Operation and Maintenance Manual, "Beeper - Set" for additional information.
   
Save Settings     Allows the operator to save the machine settings and the display settings to the Data Card.    
Restore Settings     Use the Restore Settings dialog in order to restore previously saved Display settings or machine settings.    
Diagnostics     The software for the AccuGrade System displays diagnostic information about the devices the software detects and also the GPS Receiver. Refer to Operation and Maintenance Manual, "Diagnostics - View" for additional information.    
( 1 ) This item is not a default setting. Contact your site manager for access to this item.To access the "Setup Menu" dialog complete the following steps:
Illustration 1 g01435468
Press the "Menu" key.A screen that is similar to Illustration 1 will open.Note: Changes made to the Setup Menu options take effect as soon as you exit the "Setup Menu" dialog.Working with the Setup Menu
Press the Down Arrow or