FRONT FRAME GROUP 8D7270 - Caterpillar

8D7270 FRONT FRAME GROUP Caterpillar parts 16G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA8D7270
8D-7270
8D7270

Weight: 0.45 pounds 0 kg.

Buy FRONT FRAME GROUP 8D7270 Caterpillar genuine, new aftermarket tractor parts with delivery
MOTOR GRADER,

Compatible equipment models: 8D7270:

MOTOR GRADER 16G Caterpillar

Number on catalog scheme:

Caterpillar 8D7270 Parts scheme FRONT FRAME GROUP

For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-7505 Hydraulic Jack 1
ZZ 6V-9510 Face Seal Plug 3
6V-9831 Cap As 3
6V-9509 Face Seal Plug 2
6V-9830 Cap As 2 Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Drain the hydraulic tank into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change". Note: In addition to the weight of the bottom guard, bottom guards may contain approximately 90 kg (200 lb) of the following objects: loose bolts, tools, rocks, dirt, liquids and debris.
Illustration 1 g00853562
Use Tooling (A) to support middle bottom guard (1). The weight of middle bottom guard (1) is approximately 35 kg (77 lb). Remove the bolts and middle bottom guard (1).
Illustration 2 g01051123
Remove engine side guard (1A) on the right side of the machine.
Illustration 3 g00853105
Hydraulic block (2) is bolted to the inside of the main frame just below the starting motor.
Illustration 4 g00853136
Remove hose assemblies (3) and (5).
Remove bolt (10) that secures tube assemblies (6) and (8) to the inside of the main frame in order to gain clearance for the removal of swivel tee (4). Remove swivel tee (4) from hydraulic block (2).
Remove tube assembly (8) and hose assembly (9).
Remove bolts (7) and remove hydraulic block (2).