FUEL INJECTOR GROUP 2089160 - Caterpillar

Remove Aftercooler
START BY:a. remove air cleaner group1. Drain the coolant from the engine. 2. Remove pipe (2) and the gasket from between aftercooler cover (1) and the turbocharger. If necessary, remove the O-ring seals from the pipe.3. Remove the bolts and clamps that hold tube assembles (5) to each end of the aftercooler. Remove tube assemblies (5) from each end of the aftercooler. If necessary, remove the O-ring seals from the tube assemblies. An O-ring seal on each end of the aftercooler core holds the adapters in position.4. Remove adapters (3) and the gaskets from each end of the aftercooler.5. Remove all bolts (4) that hold the gauge group and aftercooler cover (1) in position. Remove the gauge group, aftercooler cover and gasket from the engine.
Typical Example6. Remove aftercooler core (6) and the gasket from the engine. If necessary, remove the O-ring seals from the aftercooler core. Two of the bolts that hold the aftercooler housing in position are on the inside of the aftercooler housing.7. Remove the bolts and spacers that hold aftercooler housing (7) to the engine. Make a note of the location of the spacers. Remove the aftercooler housing and gaskets from the engine.Install Aftercooler
Inspect all O-ring seals and gaskets, and make replacements if necessary.
Typical Example1. Put the gaskets and aftercooler housing (1) in position on the engine, and install the bolts and spacers that hold it.2. Install the O-ring seals on the aftercooler core, and put a thin layer of clean engine oil on them. Put the gasket and aftercooler core (2) in position on the engine. 3. Put the gasket, aftercooler cover (3) and gauge group (4) in position, and install the bolts that hold them. Force may be required to push the adapters around the O-ring seals on the aftercooler core. Make sure the O-ring seals stay in position on the aftercooler core.4. Put a thin layer of clean engine oil in the bores of adapters (6). Install a gasket and adapter on each end of the aftercooler core.5. Install the O-ring seals on tube assemblies (7), and put a thin layer of clean engine oil on them. Put the tube assemblies in position on each end of the aftercooler, and install the bolts and clamps that hold them.6. Install the O-ring seals on pipe (5), and put a thin layer of clean engine oil on them. Put the pipe and gasket in position between the aftercooler and the turbocharger, and install the bolts that hold it.7. Fill the radiator with coolant to the correct level. See the Maintenance Guide for the correct procedure.END BY:a. install air cleaner group