FUSE 1243548 - Caterpillar

Push down on the power mode control button in order to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Illustration 4 g02447036
Automatic Engine Speed Control (AESC) as displayed on the programmable function key in the monitor.
Disable the automatic engine speed control through the monitor by pressing the programmable button.
Illustration 5 g02447064
Joystick (front switch)
Disable the hydraulic modulation control, if equipped. Press the front switch on the right joystick in order to deactivate hydraulic modulation.
The air conditioning should be turned off for the following test.
Lower the stabilizers, the blade tip, and/or the implement in order to raise the front axle and the rear axle. This action will allow the wheels to turn freely.Note: All tires must be fully off the ground.
Fully extend the bucket cylinder and place the bucket on the ground.
Start the Electronic Technician.
Select the Engine ECM in Electronic Technician.
Select "OK".
Select "Diagnostics" from the main menu.
Select "Diagnostic Tests".
Select "Override Parameters".
Select "Travel Pilot Solenoid Current Override" and set the current to 0.8 amp.
Set the engine speed dial at "1".
Illustration 6 g02453444
Transmission control button located on the soft panel switch
Push down on the transmission control button in order to select FIRST GEAR. Note: The first indicator light will illuminate when the transmission is in FIRST GEAR.
Illustration 7 g02453447
Creeper speed control button located on the soft panel switch
Push down on the creeper speed control button in order to activate the creeper speed control.Note: The indicator light will be illuminated when the creeper speed control is activated.Test Procedure
Press the travel pedal to the FULL FORWARD position.
Check the transmission output speed and engine speed in Electronic Technician.
Compare the transmission output speed with the specifications in Table 2.
If the transmission output speed is not within the specification, refer to the "Adjustment Procedure" to adjust the maximum displacement.Adjustment Procedure
Start the engine.
Illustration 8 g02452604
Set the engine speed dial at "1".
Place the machine in a roading position.
Push down on the transmission control button in order to select FIRST GEAR. Note: The first indicator light will illuminate when the transmission is in FIRST GEAR.
Push down on the creeper speed control button in order to activate the creeper speed control.Note: The indicator light will be illuminated when the creeper speed control is activated.
Road the machine over a minimum distance of 1 m.
Stop the machine.
Place the service brake pedal in the LOCKED position.
Illustration 9 g02792741
Travel motor ( M313D) (1) Adjustment screw for maximum displacement stroke limitation
Illustration 10 g02793257
Travel motor ( M315D) (1) Adjustment screw for maximum displacement stroke limitation
Remove the cap from adjustment screw (1) .
Loosen the locknut. Turn adjustment screw (1) clockwise until there is no noticeable contact with the swashplate.
Continue to turn adjustment screw (1) counterclockwise one additional full turn.
Tighten the locknut.
Install the cap onto adjustment screw (1) .
Prepare the machine for testing. Refer to "Machine Preparation".
Retest the transmission output speed. Refer to "Test Procedure". If the transmission output speed values are not within the specifications, test and adjust the maximum displacement of the implement pump.ReferenceRefer to Testing and Adjusting, "Main Pump (Maximum Displacement) - Test and Adjust (Test without Flow