FUSE 2672701 - Caterpillar

Electrical
The correct answers can be found elsewhere in this issue.31. Which wire would make the best conductor? a) A wire with a resistance of 20 ohmsb) A wire with a resistance of 200 ohmsc) A wire with a resistance of 2 ohmsd) A wire with a resistance of 2000 ohms32. Two 12 volt batteries connected in parallel will give you: a) A total of 12 voltsb) A total of 24 voltsc) A total of 6 voltsd) None of the above33. In a 24 volt system with a total resistance of 12 ohms, the current in the system is: a) 1/2 ampsb) 24 ampsc) 2 ampsd) None of the above34. A parallel circuit has: a) Only one pathb) Only two pathsc) Two or more pathsd) None of the above35. TRUE/FALSE: A voltmeter is usually connected in parallel in a circuit.36. TRUE/FALSE: Adding a resistor to a series circuit increases current flow.37. TRUE/FALSE: You should have power in the circuit or component when checking for continuity.38. TRUE/FALSE: A battery is made of many cells in parallel.39. TRUE/FALSE: A voltmeter could be damaged when connected in series with current flowing.40. TRUE/FALSE: When a circuit is connected so that current flow is divided when passing through the units, it is called a "series" circuit.41. TRUE/FALSE: When resistances are connected in parallel, the total resistance is less than the value of the smallest resistance.42. TRUE/FALSE: If an "open" occurs in a series circuit, no current will flow in any other part of the circuit.43. TRUE/FALSE: An ammeter indicates the current flowing through the circuit in which it is connected.44. TRUE/FALSE: Voltage drop is the difference in electrical pressure between any two points in a circuit.45. TRUE/FALSE: The current flow varies at different points in a series circuit.46. What kind of switch can starting motors use? a) Manual switchb) Magnetic switchc) Solenoid switchd) All of the above47. Motor brushes should be replaced when they are worn to: a) 25% of original lengthb) 33% of original lengthc) 50% of original lengthd) 75% of original length48. Resistances in a series circuit will always have the same: a) Resistance valueb) Current through themc) Voltage drop across themd) None of the above49. In a series circuit with 3 amps going through it, the voltage drop across a 2 ohm resistor is: a) 6 voltsb) 5 voltsc) 1 1/2 voltsd) None of the above50. A 12 ohm resistor and a 6 ohm resistor in a series circuit will give you: a) A combined resistance of 2 ohmsb) A combined resistance of 18 ohmsc) A combined resistance of 12 ohmsd) A combined resistance of 4 ohms Answers: 31.c, 32.a, 33.c, 34.c, 35.T, 36.F, 37.F, 28.F, 39.T, 40.F, 41.T, 42.T, 43.T, 44.T, 45.F, 46.d, 47.c, 48.b, 49.a, 50.b.