FUSE 3706127 - Caterpillar

Secondary Brake Test
1. Place the speed control lever in THIRD SPEED position.2. Apply the secondary brake.3. Start the engine and place the direction control in the FORWARD position.4. Run the engine at HIGH IDLE. The vehicle must not move. The secondary brake must hold the vehicle from moving.
The operator must be ready to use the service brake if the secondary brake is not adjusted correctly and the skidder starts to move.
5. If the secondary brake does not hold, repeat the steps, in Secondary Brake Adjustment.Transmission Hydraulic Control
Transmission Hydraulic Control Linkage Adjustment
1. Place the neutral lock/parking brake lever in the lock position. This places the transmission direction control handle (1) in the NEUTRAL detent.2. Place the transmission directional valve spool in NEUTRAL, the center detent position.3. Adjust cable (7) at the two bulkhead fittings (5) and (9), yoke (10) at the spool end, and ball joint (4) at the fire wall, for the correct length.4. Remove cap from top of housing assembly (3).5. Rotate control handle (1) counterclockwise until top of rack (6) is even with the top of housing assembly (3), replace cap.6. Place the transmission speed valve spool in THIRD SPEED detent. Adjust yoke (11) on connecting rod (8) and assemble to lever.7. Adjust indicator collar (2) on control handle (1) to THIRD SPEED and tighten set screw.
Transmission Hydraulic Control Linkage
(1) Control handle. (2) Indicator collar. (3) Housing assembly. (4) Yoke. (5) Bulkhead fitting. (6) Rack. (7) Cable. (8) Connecting rod. (9) Bulkhead fitting. (10) Yoke. (11) Yoke.Service/Parking Brake
Service/Parking Brake Adjustment
1. With rod end (14) disconnect from lever (15), loosen locknut (4) from bolt (5).2. Adjust bolt (5) in or out of the pedal assembly until a dimension (X) of 186 mm (7.3 in.) can be measured from the horizontal floor plate to the top rear edge of the pedal.3. Once correct pedal height is adjusted, tighten locknut (4) on bolt (5).4. Place the brake valve spool in the brake release position (spool all the way into control valve).5. Connect link (12) to the brake valve spool and to lever (13).6. Adjust rod end (14) on rod (11) to assemble to lever (15), making certain that there is still thread length at the top of rod (11) to tighten nut (9) against lever (10).7. Place neutral lock/parking brake lever (1) in the disengaged position (as shown).8. Adjust rod ends (2), (6) on rod (3) and rod end (7) on rod (11) to allow assembly of rod end (6) to rod end (7).9. Adjust nut (9) to sit on top of lever (10) without pulling lever (15). Tighten locknut (8) down on nut (9).10. Adjust locknuts against rod ends.
Service/Parking Brake Adjustment
(1) Parking brake/neutral lock lever. (2) Rod end. (3) Rod. (4) Nut. (5) Bolt. (6) Rod end. (7) Rod end. (8) Locknut. (9) Nut. (10) Lever. (11) Rod. (12) Link. (13) Lever. (14) Rod end. (15) Lever. (X) 186 mm (7.3 in.).Wheel Bearings
Adjustment Of The Wheel Bearings
Adjustment Of Wheel Bearing
(1) Spindle assembly. (2) Retainer. (3) Seal. (4) Hub