FUSE AS 4849066 - Caterpillar

Remove the generator enclosure assembly from the trailer. Use the lifting eye to lift the package.Transportation of the Enclosure Assembly
Flat Bed Trailer
Keep all non-essential personnel clear of the area.
Load the package and unload the package on a level surface.
Block the transport vehicle so the vehicle cannot move.
Keep both the trailer bed and the ramps for the trailer clean. Remove any clay, oil or other slippery materials.
If ramps are used, ensure that the ramps are of adequate size and strength. The ramps should be installed at the proper height and the angle of the ramps should be low.
Use the lifting eye of the enclosure. Ensure that all lifting devices have adequate capacity.
Chain the package or block the package securely before you transport the package.
Check the height and width of the package for clearance for traveling. Check the weight of the package for load limitations.Engine Lifting
Illustration 4 g00103219
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted. Some removals require lifting fixtures in order to obtain proper balance. Lifting fixtures also help to provide safety.To remove the engine ONLY, use the lifting eyes that are on the engine.Lifting eyes are designed and installed for the specific engine arrangement. Alterations to the lifting eyes and/or the engine make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Caterpillar dealer for information regarding fixtures for proper engine lifting.Engine Lifting with a Generator
Do not use the engine lifting eyes to remove the engine and generator together.
Place the unit on stable, level ground. Chock the wheels.Remove the enclosure assembly from the trailer. Refer to Operation and Maintenance Manual, "Enclosure Lifting" for further information.Remove the cover from the front battery compartment. Disconnect the enclosure lighting wiring harness from the trailer frame wiring harness.Disconnect the battery cables. Be sure to pull the cables out of the battery compartment through the electrical cable bushing and through the wall. This will avoid damage to the wall of the enclosure and damage to the cables.Remove the mounting nuts around the edge of the enclosure. Lift the foam liner in order to gain access to the mounting nuts. Be careful not to damage the bottom seal of the enclosure during removal.Remove the mounting bolts from the exhaust elbow of the turbocharger. The flexible exhaust piping and the exhaust silencer remain with the enclosure.Remove the rear bulkhead.Disconnect the generator leads.Disconnect the voltage regulator.Disconnect the