FUSE 5108931 - Caterpillar

start by:a) remove flywheel 1. Remove the baffle retaining bolts and locks. Use 3/8"-16 NC forcing screws to remove baffle (1) from the flywheel housing.2. Remove the crankshaft rear seal ring. 3. Install tooling (A). Heat the outer diameter of the thrower with a torch to a maximum temperature of 400°F (204°C). Use tooling (A) to remove the thrower before it becomes cool.Install Crankshaft Rear Seal Ring And Thrower
Oil throwers that have been removed must not be used again.
1. Heat the thrower to a maximum temperature of 300°F (149°C). Use tooling (A) to install the thrower on the crankshaft. 2. Put clean oil on the rear seal ring and thrower. Install rear seal ring (1) with opening at the top and the face of the seal with the mark "out" or "rear" toward the flywheel.3. Put the gasket and baffle in position on the flywheel housing. Install the locks and bolts that hold the baffle in place.end by:a) install flywheel