GAGE AS- 2624777 - Caterpillar

Illustration 1 g00692329
(1) Torque for rod end studs ... 19 4 N m (168 35 lb in) (3) Bearings are in two places. When replacement is necessary, use a driver only on the end that is stamped. (4) Torque for locknut ... 30 5 N m (22 4 lb ft) (5) LeverSteering Linkage Positions: (C) Zero steer (D) Maximum steer (E) Zero speed (G) Forward speed (H) Reverse speedNote: Before installation, use SAE 30 oil to lightly lubricate the sealing lip of the lip type seals.Adjustment Procedure
Note: Before you do the following adjustment procedure, see Servo Linkage adjustments.
Before you do the installation of rod (2), see Servo Linkage adjustments.With the steering control in maximum position (D), the play that is at the steering linkage (3) of dimension (J) and (K) is 0.05 mm (0.002 inch).
Hold dimensions (J) and (K) equal. Then adjust dimension (M) in order for dimension (A) to equal dimension (B). Dimension (A) is obtained by moving underspeed actuator linkage (L) from zero speed (E) to forward speed (G). Dimension (B) is obtained by moving underspeed actuator linkage (L) from zero speed (E) to reverse speed (H) .
Underspeed actuator linkage (L) is in a raised position and the value of dimension (J) and (K) is equal. Then adjust dimension (F) in order to put pilot valve spring (6) in the centered position.