GAGE A - 6V7898 - Caterpillar

Table 1
Service Tools
Part Number Part
6V-7070
9U-7330 Digital Multimeter
8T-3224 Needle Tip Group
7X-1710 Multimeter Probe Group
8T-8726 Adapter Cable
6V-3000 Connector Repair Kit (Sure Seal)
4C-3406 Connector Repair Kit (Deutsch)
8T-5201 Signal Generator/Counter Use the digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the 6V-7070 Digital Multimeter, see Special Instruction, SEHS7734. Use the 7X-1710 Multimeter Probe Group to measure the voltage at the wire connectors without disconnecting the wire connectors. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a three pin DT breakout. The adapter cable is used for measurements in the sensor circuits.Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended for today's Caterpillar electrical circuits.