GASKET 0358193 - Caterpillar

start by:a) remove tires and rims (front or rear)b) remove final drive planet carrier 1. Remove lockwire (2). Remove bolts (1) from nut (3). 2. Fasten tool (A) and a hoist to the wheel assembly as shown. Put an up force on the wheel assembly with the hoist.3. Use tooling (B) to remove nut (3) from the spindle. 4. Use two persons to remove ring gear (4) and hub from the spindle. The weight of the ring gear and hub is 80 lb. (36 kg). 5. Remove bolts (5). Remove locks (6) and plates and remove hub assembly (7) from the ring gear. 6. Use tooling (C) to remove bearing cone (8) from the hub.Install Final Drive Ring Gears And Hubs
1. Heat the bearing cone to a maximum temperature of 275° (135°C). Install bearing cone (1) on the hub. 2. Put hub assembly (2) in position in the ring gear. 3. Install plates (3), locks and bolts that hold the hub in the ring gear. 4. Use two persons to put ring gear (4) and hub in position on the spindle. 5. Install nut (5) on the spindle. Remove tool (A) and the hoist from the wheel assembly.6. Make an adjustment to the wheel bearings as follows: a) Use an 8 in. (20.3 cm) long torque wrench (9S7354) on the wheel stud to slowly turn the wheel assembly while nut (5) is tightened with tooling (B). Tighten nut (5) until it takes a torque of 160 50 lb.in. (18.1 5.7 N m) to turn the wheel assembly one complete revolution. Make sure the torque wrench is installed on the wheel stud so it is in line with the center of the wheel as shown.b) Loosen nut (5). Tighten nut (5) again until it takes a torque of 75 25 lb.in. (8.5 2.8 N m) to slowly turn the wheel assembly one complete revolution with an 8 in. (20.3 cm) torque wrench (9S7354) at the wheel stud. For torque wrenches of different lengths use the following formula for the correct torque: C is the torque wrench reading.A is the length of the torque wrench.B is the distance from the center of the axle housing to the wheel stud.T is torque to turn the wheel assembly.T=160 50 lb.in. (18.1 5.7 N m) for Step (a) and 75 25 lb.in. (8.5 2.8 N m) for Step (b). 7. Install bolts (7) in the hub assembly. If necessary, turn nut (5) in a clockwise direction until the holes in the nut are in alignment with the holes in the hub assembly. Install lockwire (6) through the bolts.end by:a) install final drive planet carriersb) install tires and rims (front or rear)