GASKET 0779892 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     180-3033     Stand     1    
B     180-3034     Stand     2    Start By:
Remove the engine. Refer to Disassembly and Assembly, "Engine - Remove".
Illustration 1 g01049248
Use Tooling (A) and Tooling (B) to support the engine. Remove bolts (1) . Remove clip (2) (not shown). Remove adapter plate (3) .
Illustration 2 g01049454
Remove bolts (4) . Remove nylon flange (5) .
Illustration 3 g02571480
Dimension (X) is provided for reference. (X) 82 mm (3.2 inch)
Remove bolts (7) and (8) . Discard bolts (7) and (8) . Remove hub assembly (6) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     180-3033     Stand     1    
B     180-3034     Stand     2    
Illustration 4 g02571480
Dimension (X) is provided for reference. (X) 82 mm (3.2 inch)
Slide hub assembly (6) onto the hydrostatic pump shaft until the internal snap ring (not shown) rests against the end of the pump shaft. The distance between the face of hub assembly (6) to the face of the pump should be approximately the distance of Dimension (X) . Install new bolts (7) and (8) .
Tighten bolt (8) to a torque of 33 7 N m (24 5 lb ft). Then tighten bolt (7) to a torque of 33 7 N m (24 5 lb ft).
Repeat Step 2 in order to ensure the proper torque.
Illustration 5 g01049454
Install nylon flange (5) . Install bolts (4) .
Illustration 6 g01049248
Use Tooling (A) and Tooling (B) to support the engine. Install adapter plate (3) . Install clip (2) (not shown). Install bolts (1) .End By: Install the engine. Refer to Disassembly and Assembly, "Engine - Install".