GASKET 0882272 - Caterpillar

Removal Procedure
Start By:
Remove the Clean Emission Module (CEM). Refer to Disassembly and Assembly, "Clean Emission Module (CEM) - Remove" for the correct procedure.
Remove the flexible exhaust pipe. Refer to Disassembly and Assembly, "Flexible Exhaust Pipe - Remove and Install" for the correct procedure.
Illustration 1 g03798717
If necessary, cut cable straps (4) from harness assembly (5). Position the harness assembly away from bracket (1).
Remove bolts (2) and bolts (3) from bracket (1).
Remove bracket (1).
Illustration 2 g03798718
Remove bolts (7) and bolts (8) from bracket (6).
Remove bracket (6) from bracket (9) and bracket (11).
Remove bolts (10) from bracket (11). Remove the bracket from the cylinder head.
Illustration 3 g03798719
Remove engine lifting brackets (12). Refer to Disassembly and Assembly, "Engine Lifting Bracket - Remove" for the correct procedure.
Remove bolts (13) from bracket (6). Support the bracket as the bolts are removed.
Remove bracket (6) from the cylinder head. Installation Procedure
Ensure that all the components are free from wear or damage. Replace any component that is worn or damaged.
Illustration 4 g03798719
Position bracket (6) onto the cylinder head.
Install bolts (13) to bracket (6). Support the bracket as the bolts are installed.
Tighten bolts (13) to a torque of 45 N m (33 lb ft).
Install engine lifting brackets (12). Refer to Disassembly and Assembly, "Engine Lifting Bracket - Remove" for the correct procedure.
Illustration 5 g03798718
Illustration 6 g03798717
Position bracket (11) onto the cylinder head. Install bolts (10) to the bracket. Hand tighten the bolts.
Position bracket (6) onto bracket (9) and bracket (11). Install bolts (7) and bolts (8) to the brackets. Hand tighten the bolts. Support the bracket as the bolts are installed.
Position bracket (1) onto bracket (6) and the front bracket.
Install bolts (2) and bolts (3) to bracket (1) hand tighten the bolts.
Tighten bolts (3) to a torque of 45 N m (33 lb ft).
Tighten bolts (2) to a torque of 45 N m (33 lb ft).
Tighten bolts (7), bolts (8), and (10) to a torque of 25 N m (221 lb in).
If necessary, position the harness assembly onto bracket (1). Install new cable straps (4) to the harness assembly Note: Ensure that the cable straps meet the Original Equipment Manufacture (OEM) specification.End By:
Install the Clean Emission Module (CEM). Refer to Disassembly and Assembly, "Clean Emission Module (CEM) - Remove" for the correct procedure.
Install the flexible exhaust pipe. Refer to Disassembly and Assembly, "Flexible Exhaust Pipe - Remove and Install" for the correct procedure.