GASKET 1032796 - Caterpillar

Illustration 2 g02709177
Tooling group (D)
Table 2
Required Tools    
Tool    Item    Part
Number    Description    Qty    
B     198-4240     Digital Pressure Indicator Gp     1    
    B1     198-4234     Indicator     1    
B2 198-4239     Pressure Sensor
41,368 kPa (6,000 psi)     1    
B3 198-4236     Extension Cable     1    
D     D1     6V-7788     Flow Meter
5 to 60 L/min (2 to 15 US gpm)     1    
D2 8C-6874     Reducer     1    
D3 6V-9746     O-Ring Seal     1    
D4 124-1901     Permanent Coupling     1    
D5 122-6870     Bulk Hydraulic Hose     3 ft    
D6 124-2147     Permanent Coupling     1    
D7 6V-8942     O-Ring Reducer     1    
D8 6V-8556     Nut     1    
D9 6V-8398     O-Ring Seal     1    
F     311-1362     Vacuum Cap     1    Machine Preparation
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release".
Attach 311-1362 Vacuum Cap onto the hydraulic tank. Attach an air supply hose onto the assembly. Apply 276 to 414 kPa (40 to 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 3 g02788993
Swing motor compartment (1) Case drain hose (2) Adapter
Disconnect case drain hose (1) from adapter (2) .
Illustration 4 g02352913
Flow Meter Tool LayoutTooling D (1) Case drain hose (2) Adapter (3) Swing motor (4) Swivel
Connect the flow meter assembly (D) between adapter (2) and case drain hose (1). Refer to Illustration 4.Note: Correct orientation of the flow meter is necessary. The oil flows from swing motor (3) to swivel (4) .
Swing solenoid valve location.
Illustration 5 g02788999
Pilot manifold (5) Connector (6) Solenoid valve for swing parking brake
Disconnect connector (5) from the solenoid valve for swing parking brake (6) .
Remove 311-1362 Vacuum Cap and install the filler plug for the hydraulic tank.Test Procedure
Start the engine.
Place the engine speed dial at position "10" and AEC switch OFF.ReferenceRefer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Slowly move the swing joystick and make sure that the swing parking brake is activated.
Move the swing joystick fully for 1 minute. Measure the