GASKET-PUMP 1102404 - Caterpillar

Illustration 1 g06337774
Track Roller Location Dimensions for the Salt Undercarriage
(D1) 1476.6 mm (58.13 inch)
(D2) 1242.9 mm (48.93 inch)
(D3) 972.3 mm (38.28 inch)
(D4) 738.2 mm (29.06 inch)
(D5) 503.7 mm (19.83 inch)
(D6) 233.7 mm (9.20 inch)
Illustration 2 g06337777
Track Roller Location Dimensions for the SystemOne Undercarriage
(D1) 1476.6 mm (58.13 inch)
(D2) 1242.9 mm (48.93 inch)
(D3) 1009.2 mm (39.73 inch)
(D4) 775.5 mm (30.53 inch)
(D5) 541.8 mm (21.33 inch)
(D6) 233.7 mm (9.20 inch)
Position the track roller assemblies according to the dimensions in the Illustrations above depending on the type of undercarriage. Position the first track roller (R1) and then position the other track rollers according to the appropriate dimensions.
Illustration 3 g01360799
Use Tooling (C) and a suitable lifting device to position track roller (5). The weight of track roller (5) is approximately 36 kg (80 lb).
Install bolts (6).Note: Refer to Table 2 for torque specifications for bolts (6).
Table 2
BOLT SIZE TORQUE SPECIFICATION
M12 120 20 N m (89 15 lb ft)
M16 270 40 N m (199 30 lb ft)
If necessary, repeat Steps 2 and 3 for remaining track rollers (5).
Illustration 4 g01410722
Install track guide guard (4).
Repeat Step 5 for the inside track guide guard.
Illustration 5 g01360774
Use two people to install track roller guard (3). The weight of track roller guard (3) is approximately 27 kg (60 lb).
Repeat Step 7 for the inside track roller guard.
Illustration 6 g01360714
Illustration 7 g01360724
Use Tooling (A) to raise the machine.
Remove Tooling (B).
Lower the machine with Tooling (A).
Remove Tooling (A).
Illustration 8 g02725330
Turn relief valve (2) clockwise to close relief valve (2).
Adjust the track assembly. Refer to Operation and Maintenance Manual, "Track -Check/Adjust".
Illustration 9 g01360245
Install access cover (1).