GASKET 1136200 - Caterpillar

There may be several specific safety messages on your engine. The exact location and a description of the messages are reviewed in this section. Please become familiar with all of the messages.Ensure that all of the messages are legible. Clean the messages or replace the messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap for cleaning the messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. The messages that are loosened could drop off of the engine.Replace any message that is damaged or missing. If a message is attached to a part of the engine that is replaced, install a new message on the replacement part. Your Caterpillar dealer can provide new messages.The safety messages that may be attached on the engine are illustrated and described below.
Illustration 1 g01290927
Do not operate or work on this engine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Flash Fire (1)The safety messages for flash fire are located on the crankcase covers.
Illustration 2 g00964061
Flash fire may result in personal injury, if crankcase covers are removed within fifteen minutes after emergency shut down. Do not restart engine until cause for shutdown has been corrected.
Hot Fluid Under Pressure (2)The safety messages for hot fluid under pressure are located on the covers of the fuel filter and the oil filter.
Illustration 3 g00306243
Filter contains hot pressurized fluid when engine is running. Follow instructions on control valve to avoid injury if rapid air movement exists to blow fluid. Stop engine to avoid fire.
Electrical Shock (3)The safety messages for electrical shock are located on the electronic control module (ECM) , the backup ECM , and the valve covers.
Illustration 4 g00103125
Electrical shock hazard. The electronic unit injector system uses 90-120 volts.
The ECM sends a high voltage signal to the unit injectors. To help prevent personal injury, disconnect the unit injector connector. Do not come in contact with the harness connector for the unit injector while the engine is operating.High Voltage (4)This safety message is located on the jacket water heater.
Illustration 5 g00481390
Power source must be disconnected before working on equipment.Failure to disconnect power source could result in injury or death.
Engine Lifting (5)The warning message for lifting the engine is located on the valve covers.
Illustration 6 g00964059
Improper lift rigging can allow unit to tumble causing injury and damage.
Before lifting the engine, read this Operation and Maintenance Manual, "Product Lifting" topic (Operation Section).If improper equipment is used to lift the engine, injury and damage can occur. Use cables that are properly rated for the weight. Use a spreader bar and attach the cables according to the information on the warning label.