GASKET KIT 1271519 - Caterpillar

Illustration 1 g00689008
Note: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all the bores for pins with lubricant. (1) 141-3477 Pin Diameter after plating ... 99.850 0.040 mm (3.9311 .0016 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (2) 087-5548 Bearing Quantity ... 2 Outside diameter ... 116.230 0.013 mm (4.5760 .0005 inch) Inside diameter ... 100.29 0.02 mm (3.948 .001 inch) Install the bearing in the bearing bore. ... 9.8 0.8 mm (0.39 .03 inch) (3) Lubricate the sealing lip slightly with the lubricant that is being sealed. (4) 141-3476 Pin Diameter after plating ... 79.850 0.040 mm (3.1437 .0016 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (5) 4I-5015 Pin Diameter after plating ... 79.85 0.04 mm (3.144 .002 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (6) 7Y-5128 Bearing Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 .0005 inch) Inside diameter ... 80.25 0.02 mm (3.159 .001 inch) Install the bearing in the bearing bore. ... 5.5 0.8 mm (.22 .03 inch) (7) Position the four nuts past the end of the four bolts. ... 0.5 mm (.02 inch) (8) Torque for four nuts (8) against four nuts (7) ... 460 60 N m (340 44 lb ft) (9) 163-3491 Pin Diameter after plating ... 99.850 0.040 mm (3.9311 .0016 inch) Minimum thickness for plating ... 0.013 mm (.0005 inch) (10) 133-2427 Shim thickness ... 0.5 mm (.02 inch)Note: Locate the above shim next to the power link. Locate the shims below next to the idler link. (11) Use the necessary shims to adjust maximum lateral clearance. Maximum clearance ... 0.8 mm (.03 inch) 133-2431 Shim thickness ... 0.5 mm (.02 inch) 133-2440 Shim thickness ... 1.0 mm (.04 inch) 133-2475 Shim thickness ... 1.6 mm (.06 inch) 133-2478 Shim thickness ... 2.0 mm (.08 inch)