GASKET KIT 1323444 - Caterpillar

Introduction
This special instruction covers the installation procedure for 239-8693 Hydraulic Pedal Control Gp .Required Parts
Table 1
239-8693 Hydraulic Pedal Control Gp
-03    
Item    Qty    Part No    Description    
(1)     1     122-9611     Pedal - Rubber    
(2)     1     153-8762     Pedal Assembly    
(3)     1     153-8763     Support Assembly    
(4)     1     233-5260     Lanyard    
(5)     1     206-3336     Pilot Valve Gp    
(6)     1     357-3877     Pin    
(7)     2     095-0735     Screw    
(8)     2     7X-2536     Bolt    
(9)     1     8T-0114     Pin - Spring    
(10)     3     8T-4121     Washer    
(11)     2     8T-4136     Bolt    
(12)     1     8T-4137     Bolt    
(13)     2     8T-4224     Washer    Installation Procedure
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag, or a similar warning tag, to the start switch or controls before you service or repair the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.
Illustration 2 g02230733
This control group is designed for use on the Caterpillar hydraulic excavator to enable hydromechanical work tools. This control group activates hydraulic pressure to the auxiliary function circuit of the work tool.
Remove the floor mat from the cab.
Illustration 3 g02230774
Locate the small access panel on the floor of the cab. Remove the panel in order to install the pedal assembly.
Position the floor mat on the floor of the cab.
Mark the area of the access hole on the floor mat.Note: The size of the hole in the floor mat should be approximately the same size as support assembly (3) .
Remove the floor mat. Remove the material within the marked area of the mat.
Properly position the floor mat on the floor of the cab.
Illustration 4 g02231194
Mount support assembly (3) to the cab floor. Secure support assembly (3) with bolt (12) and washer (10) .
Insert valve group (5) through the support assembly (3) .Note: Port "T" of valve (7) should be facing toward the front of the machine.
Secure valve group (5) to the cab floor with bolts (11) and washers (10) .
Mount pedal assembly (2) to valve group (5). Use bolts (8) and washers (13) .Note: Tighten bolts (8) to 16.7 1.5 N m (12 1 lb ft)
Install rubber pedal (1) over pedal assembly (2) .
Illustration 5 g02229354
Spring Pin and Lanyard mounting detail
Install the spring pin (9) in pin (6). Refer to Illustration 5.
Fasten lanyard (4) onto the head of pin (6). Use screw (7). Refer to Illustration 5.
Fasten the opposite end of lanyard (4) onto support assembly (3). Use screw (7) .
Insert the pin (6) into the desired position in support assembly (3) .