GASKET KIT 1441141 - Caterpillar

Start By:a. remove front wheel spindles 1. Remove bolt (1), the washer and the retainer from the pin that holds the wheel lean cylinder to wheel lean arm (14).2. Remove bolt (2), the washer and the retainer from the pin that holds wheel lean arm (14) to wheel lean bar (8).3. Remove bolts (1), (2), the washers and the retainers from the pin that holds the other end of wheel lean bar (8) to the left end of wheel lean arm (14).4. Remove two bolts (4), two small washers and two large washers from the pin that holds wheel lean arm (14) to axle (13). 5. Remove bolt (11) and the nut that secures pin (10) to wheel lean arm (14) and axle (13). Remove pin lock (12) from wheel lean arm (14). Place wooden blocks (7) under the wheel lean cylinder and wheel lean bar (8). 6. Attach lifting slings and a hoist to wheel lean bar (8). Remove wheel lean bar (8). The weight of wheel lean bar (8) is 44 Kg (97 lb). 7. Attach a lifting sling and a hoist to right side wheel lean arm (14). Remove pin (10) from axle (13) and right side wheel lean arm (14). Move right side wheel lean arm (14) clear of axle (13). Move right side wheel lean arm (14) forward in order to slide pin (9) out of the wheel lean cylinder rod end. Remove right side wheel lean arm (14) from the machine. The weight of wheel lean arm (14) is 30 Kg (66 lb).8. Left side wheel lean arm (14) has no wheel lean cylinder. Repeat Steps 3 through 7 in order to remove left side wheel lean arm (14). During Step 7 wheel lean bar (8) was removed from pin (9) in the left hand wheel lean arm. Pin (9) will stay in both wheel lean arms. 9. Remove lip seal (5) from right side wheel lean arm (14). Use Tooling (C) in order to remove bearing (6) from right side wheel lean arm (14). For installation purposes, note that the location of the groove in the bearing matches the location of the grease zerk in the wheel lean arm. 10. Use Tooling (C) in order to remove bearing (3) from right side wheel lean arm (14). For installation purposes, note that the location of the groove in the bearing matches the location of the grease zerk in the wheel lean arm.11. If pin (9) is worn or damaged, use a press and Tooling (E) in order to press the pin out of the wheel lean arm. Pin (9) extends to both sides of the right side wheel lean arm. Pin (9) extends to only one side of the left side wheel lean arm.12. Repeat Steps 8 thru Steps 11 in order to remove the lip seal, bearings and pin (9) from the left side wheel lean arm. Notice that the pin in the left side wheel lean arm only extends out