GASKET HOUSING 1541825 - Caterpillar

Press "OK" (9) to select this item.
Illustration 72 g01131669
Observe the measured "Machine Voltage". The "Machine Voltage" is shown in volts.Note: For the components in the system to run properly, "Machine Voltage" should be between 9 VDC and 32 VDC. For details on components voltage requirements.
Press "OK" (9) to return to the "Diagnostics" Menu.
Turn the "Power/Setup" Switch (7) to the "ON" position to return to Guidance Mode."Test Control Box" Menu
Use the "Test Control Box" Menu to test that the configured switches in the system work correctly and to test that the LCD works correctly.The switches available for testing include the switches on the Display and the remote switches. All switches are available for testing except for the "Power/Setup" Switch (7) .Note: Testing "Esc" Button (8) or "OK" (9) returns you to the "Diagnostics" Menu.
From the "Diagnostics" Menu, toggle a "Menu Scroll" Switch (2,3) until Test Control Box is highlighted on the LCD.Refer to Illustration 73.
Illustration 73 g01143675
Press "OK" (9) to select this item.A screen similar to Illustration 74 appears.When you enter the "Test Control Box" Menu, the Display checks that all the LEDs are functioning properly.
Illustration 74 g01131723
Test each switch configured in the system.Remote switches are labeled A, B, C, D, and E. Panel switches are labeled P1, P2, P3, P4, P5, P6, and P7.The arrow shown next to a remote switch identifier determines which switch is pressed and whether the switch is up or down:
Table 4
A remote switch that     is represented by a flashing identifier and    
has a short to power     the "+" symbol    
has a short to ground     the "-" symbol    
is not detected by the system     the "?" symbol    
Test that the complete LCD is working by performing the following steps:
Simultaneously toggle both "Menu Scroll" Switches (2,3) up to turn on all the LCD pixels.The display turns black.
Simultaneously toggle both "Menu Scroll" Switches (2,3) down to turn off all the LCD pixels.The display turns green.
Press "OK" (9) to return to the "Diagnostics" Menu.
Turn the "Power/Setup" Switch (7) to the "ON" position to return to Guidance mode.Installation Menu
Illustration 75 g01362875
Installation MenuThe Installation menu is used to set up AccuGrade - Grade Control System after the electronic components installation. This section describes the menus and the function of the menu. For additional information refer to the Testing and Adjusting section of this manual.The installation Menu contains the options listed below:Language
The Language menu allows you to choose the language that will be used on the Display from a list of available languages.
Illustration 76 g01048315
"Language" Menu"Machine Setup"
The Machine Setup menu contains a series of menus for configuring the system to the machine.
Illustration 77 g01362891
"Machine Setup" Menu"Calibration"
The "Calibration" menu is a series of menus that are used in order to calibrate the machine's sensors, valves and linked elevation.
Illustration 78 g01362894
"Performance"
The blade has a tendency to dip as the circle is rotated. The "Performance" menu uses the "Dip Reduction" option in order to counteract the movement of the blade.
Illustration 79 g01155285
"Performace" Menu"Reset to Default"
Illustration 80 g01371248