GASKET-CYLINDER BLOCK 1669145 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Fuel System - Prime
Every 6 Years
Cooling System Coolant (ELC) - Change
Standby Generator Set Maintenance Recommendations
Every Week
Automatic Start/Stop - Inspect
Battery Electrolyte Level - Check
Battery Charger - Check
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Instrument Panel - Inspect
Jacket Water Heater - Check
Radiator - Clean
Standby Generator Set Maintenance Recommendations
Walk-Around Inspection
Every Year
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Performance - Test
Engine Protective Devices - Check
Engine Valve Lash - Inspect/Adjust
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Magnetic Pickups - Clean/Inspect
Standby Generator Set Maintenance Recommendations
Starting Motor - Inspect
Water Pump - Inspect
Every 3 Years
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Hoses and Clamps - Replace
Standby Generator Set Maintenance Recommendations
Turbocharger - Inspect