GASKET KIT - 1746836 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Overhaul Considerations
Stator Winding Temperature - Test
Valve Stem Projection - Measure/Record
Varistor - Inspect
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Walk-Around Inspection
Every 250 Service Hours
Engine Oil Sample - Obtain
Every 750 Service Hours
Aftercooler Core - Clean/Test
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Oil and Filter - Change
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Exhaust Piping - Check
Hoses and Clamps - Inspect/Replace
Ignition System Timing - Check/Adjust
Radiator - Clean
Spark Plugs - Inspect/Adjust/Replace
Initial 750 Service Hours
Gas Pressure Regulator - Test
Valve Stem Projection - Measure/Record
Every 1500 Service Hours
Actuator Control Linkage - Lubricate
Carburetor Air/Fuel Ratio - Check/Adjust
Crankcase Blowby - Test/Record
Cylinder Pressure - Test/Record
Engine Crankcase Breather - Clean
Engine Oil Filter (Auxiliary) - Change
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Gas Pressure Regulator - Test
Speed Sensor - Clean/Inspect
Every 3000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Coolant Sample (Level 2) - Obtain
Driven Equipment - Check
Engine Mounts - Inspect
Ignition System Transformer Resistance - Test
Starting Motor - Inspect
Water Pump - Inspect
Every 4000 Service Hours
Alternator - Inspect
Every 8000 Service Hours
Turbocharger - Inspect
Between 9000 and 12 000 Service Hours
Overhaul (Top End)
Between 18 000 and 24 000 Service Hours