GASKET KIT - 1749469 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Generator - Dry
Generator Set - Test
Stator Winding Temperature - Test
Varistor - Inspect
Daily
Generator Load - Check
Power Factor - Check
Every Week
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Automatic Start/Stop - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Jacket Water Heater - Check
Standby Generator Set Maintenance Recommendations
Every 250 Service Hours or 1 Year
Engine Oil and Filter - Change
Every 6 Months
Stator Lead - Check
Every Year
Actuator Control Linkage - Lubricate
Aftercooler Core - Clean/Test
Air Starting Motor Lubricator Bowl - Clean
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Carburetor Air/Fuel Ratio - Check/Adjust
Coolant Sample (Level 1) - Obtain
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankcase Blowby - Test/Record
Crankshaft Vibration Damper - Inspect
Cylinder Pressure - Test/Record
Engine - Clean
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Performance - Test
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Exhaust Piping - Check
Gas Pressure Regulator - Test
Hoses and Clamps - Inspect/Replace
Ignition System Timing - Check/Adjust
Radiator - Clean
Spark Plugs - Inspect/Adjust/Replace
Speed Sensor - Clean/Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 3 Years
Coolant (NGEC) - Change