GASKET 1794382 - Caterpillar

Illustration 22 g00594365
Position plate (34) to oil pan assembly (3) , as shown. Install 15 bolts (34) and the washers that hold plate (34) to oil pan assembly (3) .
Tighten the bolts (X) first. Tighten the remaining bolts in the sequence, as shown.Note: Ensure that the mating surface of the oil pan is clean and free of foreign material prior to installing the gasket.
Install five gaskets (32) to oil pan assembly (13) , as shown. Apply Loctite 595 or 138-8436 Liquid Gasket to oil pan (13) as it is necessary.
Apply Loctite 595 or 138-8436 Liquid Gasket to all the joints of five gaskets (31) .
Illustration 23 g00596842
Illustration 24 g00596839
Illustration 25 g00596837
Note: Ensure that the mating surfaces of the engine are clean and free of foreign materials prior to installing the oil pan assembly.
Position Tool (A) (not shown) or a suitable jack under oil pan assembly (3) . Install integral seal (29) to oil pan assembly (3) . Slowly raise oil pan assembly (3) and five gaskets (32) to the engine, as shown. The weight of oil pan assembly (3) is 65 kg (143 lb).
Install nine bolts (28) and the washers that hold oil pan assembly (3) to oil pan (24) .
Install nine bolts (29) and 22 bolts (30) that hold oil pan assembly (3) to the engine. Apply 4C-9508 Wicking Sealant to 22 bolts (30) after installation, as required.
Illustration 26 g00594085
Position tube assembly (22) , as shown. Install two bolts (27) and the washers that hold clamp assembly (26) to base adapter (25) .
Illustration 27 g00594084
Install two bolts (23) , the washers, the spacers, and the clips that hold tube (22) to oil pan (24) .
Illustration 28 g00594083
Install two bolts (20) and the washers that hold clamp assembly (21) to adapter (19) .
Illustration 29 g00596836
Position accumulator charging valve (18) to the frame assembly. Install two bolts (17) and the washers that hold accumulator charging valve (18) to the frame assembly.
Illustration 30 g00596833
Connect two hose assemblies (14) and (15) to steering valve (16) .
Illustration 31 g00596830
Connect two hose assemblies (12) and (11) to plug adapter (13) .
Illustration 32 g00603131
Position pump inlet elbow (10) , tube (6) , and oil pan elbow (7) to oil pan assembly (3) as a unit. Install four bolts (8) and the washers that hold oil pan elbow (7) to oil pan assembly (3) . Install two bolts (9) and the washers that hold pump inlet elbow (10) to engine oil pump (5) .
Illustration 33 g00603129
Connect wire harness (4) at the electrical connection. Install four bolts (1) and the washers that hold elbow assembly (2) to oil pan assembly (3) .
Fill the engine with engine oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.
Refer to Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" for the correct refill capacity.End By:
Install the crankcase guards. Refer to Disassembly and Assembly, "Crankcase Guard - Remove and Install".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".