GASKET 1913921 - Caterpillar

g01371647
Connect the steering frame lock between the front and the rear frames before lifting, transporting, or servicing the machine in the articulation area. Disconnect the steering frame lock and secure the steering frame lock before resuming operation. Severe injury or death could occur.
Hydraulic System Oil (12)This safety message is positioned near the hydraulic tank filler cap and this safety message is located near the hydraulic tank sight gauge.
g01637005
If the incorrect hydraulic oil viscosity is installed and the machine is operated in cold temperatures, the machine hydraulic system may not respond at normal speeds. Sluggish machine control could result in injury or death. Use the correct oil viscosity for operating the machine in cold weather, and warm-up the machine before operating the machine in cold weather. See Operation and Maintenance Manual, "Engine and Machine Warm-Up" for more information on operation in cold temperatures. See Operation and Maintenance Manual, "Lubricant Viscosities" for the recommended oil viscosity. If the hydraulic oil needs to be changed, see Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the procedure to change the hydraulic system oil.
High Pressure (13)This safety message is located on the engine on the left side of the machine.
g01381180
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Accumulator (14)This safety message is positioned on the brake accumulators. The brake accumulators are located at the rear of the cab.
g01371642
Cold ambient temperatures could result in the loss of secondary braking capability due to inadequate hydraulic accumulator nitrogen pre-charge. The loss of the secondary braking system as well as the main hydraulic pressure will result in little or no braking capability and a potential for injury or death.It is recommended to perform a brake accumulator check anytime the machine has been idle for longer than two hours below -25 °C (-13 °F). Refer to Operation and Maintenance Manual before performing any check of the brake accumulator.
High Pressure Cylinder.Rapid discharging from disconnecting or disassembly can result in personal injury or death. See your Caterpillar dealer for tools and instructions for relieving pressure or charging. Precharge only with dry nitrogen gas.
Accumulator (15)This safety message is located on the blade cushion accumulator which is located on the left-hand side of the front frame.
g01123184
High Pressure Cylinder.Rapid discharging from disconnecting or disassembly can result in personal injury or death. See your Caterpillar dealer for tools and instructions for relieving pressure or charging. Precharge only with dry nitrogen gas.
Refer to Operation and Maintenance Manual, "Blade Cushion Accumulator - Check" for more information.Recoil Spring (16)This safety message is positioned at the bottom of the parking brake housing.
g01379131
This housing contains a highly compressed spring that can cause injury or death. Do not disassemble this parking brake housing until you have read and understand the correct procedure for disassembly in the Service Manual.