GASKET 1R5334 - Caterpillar

Event Resetting
There are three ways to reset events.
One method is to reset the individual active events by navigating to the desired event in the event log. However, this method applies only to the EMCP 4 generator set control (GSC) units.
The second method is to reset all active events in the event log for that module by navigating to one of the active events in that event log. However, this method applies to all modules other than the EMCP 4.
The third method is an approach that resets all active events for all modules. The control must be placed in stop in order to reset active shutdown events.Resetting Individual Active Events
To reset individual events of the EMCP 4, start by navigating to the event log:
Press the stop key.
Illustration 1 g02258434
The "EVENT LOG" menu can be accessed two ways:
Illustration 2 g02258435
Select "VIEW" on the display and press the "OK" key.
Use the "EVENT LOG" key in order to navigate directly to the event log.
Illustration 3 g02258438
Press the up key or the down key to select "GENSET CONTROL". Press the "OK" key. A screen that is like Illustration 4 will appear.
Illustration 4 g02258453
Use the up and down keys to scroll through the list of events and find the active event that requires resetting. Generally, events are ordered by the statues of the event. Present events are listed first, followed by active events, and finally the inactive events. Within each status, the events are listed with the most recent first.
Illustration 5 g02258575
Press the "OK" key to enable the reset feature. Refer to Illustration 6.
Illustration 6 g02258579
Press the "OK" key to reset the event. Notice that the event changes from active to inactive. Resetting all Active Events for a Single Module
The second method to reset events, applies to all modules other than the ECMP 4. The process involves resetting all of the active events of the module by navigating to one of the active events in the event log. This method does not apply to the EMCP 4 generator set control log.With any method, the control must be in stop mode. A key difference between the EMCP 4 and all other modules is that the other modules do not display a "PRESENT" status for events.Events are shown as "ACTIVE " if currently affecting the system, or as "INACTIVE" if the event is not affecting the system.To reset all of the active events on any individual module except the EMCP 4, which is listed as "GENSET CONTROL" in the event log, start by navigating to the event log.
Illustration 7 g02258434
At the main menu, press the down key to highlight "VIEW". Press the "OK" key. Refer to Illustration 1.
Illustration 8 g02258435
Select "EVENT LOGS". Press the "OK" key. Refer to Illustration 2.
Illustration 9 g02258617
Press the up or down keys to select the desired log. Press the "OK" key. Refer to Illustration 9.
Illustration 10 g02258620
Press the "OK" key to view the first event details. Refer to Illustration 10.