GASKET 2056586 - Caterpillar

Illustration 3 g00746975
Use a suitable hoist and a suitable lifting sling in order to place steering cylinder (3) on Tooling (A). The weight of steering cylinder (3) is 105 kg (230 lb).
Illustration 4 g00746974
Use the hoist and Tooling (A) in order to lift steering cylinder (3) into position, as shown.
Illustration 5 g00746971
Illustration 6 g00746972
Note: Use two persons for the following steps.
Use one person in order to guide steering cylinder rod end (3) through the opening in the frame, as shown.
Use one person in order to guide the head end onto the frame, as shown.
Illustration 7 g00746964
Install Tooling (B) in order to support steering cylinder (3) .
Illustration 8 g00746969
Install pin (17), the bolt (16) and the washer.
Illustration 9 g00746968
Connect grease line (15) to steering cylinder (3) .
Illustration 10 g00746967
Connect hose assembly (14) .
Illustration 11 g00746966
Install bolt (12), the washer, and the clamp.
Connect tube assembly (13) .
Illustration 12 g00747021
Install hose assembly (11) .
Illustration 13 g00747016
Install bolt (10), the washer and the clip.
Connect tube assembly (9) .
Illustration 14 g00746965
Install hose clip (7), and (8) .
Illustration 15 g00746964
Remove Tooling (B) .
Illustration 16 g00746962
Use the machine's hydraulics in order to extend the steering cylinder rod.
Install pin (5), bolt (4) and the washer.
Illustration 17 g00753297
Install Tooling (A) under guard assembly (2) , as shown.
Carefully raise Tooling (A) in order to raise guard assembly (2) .
Install four bolts (1) and the washers.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.