GASKET 2801383 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     161-4163 (1)
or
161-4164 (2)     Piston Ring Compressor     1    
( 1 ) Use with C-10 Engines
( 2 ) Use with C-12 Engines
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply clean engine oil on the following items: the piston, the piston rings and the cylinder bore.
Install Tooling (A) in order to compress the piston rings.
With the number one crankshaft throw at the bottom center, install the piston and connecting rod in the engine. Ensure that the proper piston and connecting rod are in the corresponding cylinder with the bearing retainer notch toward the right side of the engine.Note: The word "FRONT" may be stamped on the crown of the pistons in some engines. Ensure that the word "FRONT" is toward the front of the engine when the piston is installed. The etched number on the connecting rod must be on the right side of the engine in the corresponding cylinder.
Illustration 1 g01064123
Line up the piston and connecting rod (3) with the crankshaft. Use a soft hammer and tap the piston into the cylinder bore until Tooling (A) comes off of the piston.
Before the connecting rod comes in contact with the crankshaft, install the upper half of connecting rod bearing (4) . Ensure that the bearing tab engages with the slot in the connecting rod.
Apply clean engine oil on the surface of the upper half of connecting rod bearing (4) . Use a soft hammer in order to tap the piston into the cylinder bore while you guide the connecting rod onto the crankshaft.
Illustration 2 g01064122
Place the lower half of the connecting rod bearing in corresponding connecting rod cap (2) . Ensure that the bearing tab engages with the groove in connecting rod cap (2) .
Apply clean engine oil on the surface of the lower half of the connecting rod bearing. Install connecting rod cap (2) on the connecting rod. Ensure that the number on connecting rod cap (2) matches the number on the connecting rod. Ensure that the numbers are on the same side.
Install connecting rod cap bolts (1) . Tighten the bolts to a torque of 130 7 N m (95 5 lb ft).
Place an index mark on each bolt head. Tighten each bolt for an additional 60 5 degrees (1/6 turn).
Repeat Steps 1 through 10 for the remaining pistons and connecting rods.End By:
Install the piston cooling jets. Refer to Disassembly and Assembly, "Piston Cooling Jets - Remove and Install".
Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".