GASKET 2831277 - Caterpillar

Illustration 1 g03597836
Table 1
Specification for 296-3008 Blade Lift Gp
Item Qty Part Specification Description
1 1 288-0735 Bolt Torque to 50 10 N m (37 7 lb ft).
2 As required, use the thrust washers to obtain minimum gap between lift arm and frame center shift plates.
Note: First shim shall be placed in rear of the joint. For any additional shims being used, split between the front and rear as best as possible.
2 8D-4336 Thrust Washer Thickness of one thrust washer is 1.90 0.18 mm (0.075 0.007 inch).
4 As required, use the shims to obtain maximum end play of 0.25 mm (0.010 inch). So yoke assembly (3) will rotate without binding.
8 7D-8879 Shim Thickness of one shim is 0.13 mm (0.005 inch).
6 7D-8881 Shim Thickness of one shim is 0.25 mm (0.010 inch).
2 7D-8882 Shim Thickness of one shim is 0.51 mm (0.020 inch).
5 1 8X-5107 Pin Diameter is 60.26 0.03 mm (2.372 0.001 inch).
Illustration 2 g03597856
View of area C
Table 2
Item Qty Part Specification Description
- Do not use impact type driver to assemble bearings.
6 1 7D-8889 Bearing Diameter is 76.352 0.050 mm (3.0060 0.0020 inch).
7 1 8D-8168 Bearing Diameter is 63.65 0.05 mm (2.506 0.002 inch).