GASKET 2920851 - Caterpillar

2. Slide boot (1) off of the electric starting motor terminal. 3. For installation purposes, put identification marks on all wires that are connected to the electric starting motor and the solenoid.4. Disconnect three main cables (2) from the positive (+) terminal on solenoid (3).5. Remove boot (4). 6. Remove starter terminal (6).7. Fasten a lifting sling and a hoist to electric starting motor (5). Remove three bolts (7) that hold the electric starting motor to the flywheel housing. Carefully remove the electric starting motor and the O-ring seal, not shown, from the flywheel housing. The weight of the electric starting motor is 25 kg (55 lb). The following steps are for the installation of the electric staring motor. Make sure the mounting surfaces on the flywheel housing and the electric starting motor are thoroughly clean prior to installation.8. Check the condition of the O-ring used between the electric starting motor and the flywheel housing. If the O-ring is damaged, use a new part for replacement. Apply glycerin to the O-ring before installation of the electric starting motor.9. Install three bolts (7) that hold the electric starting motor to the flywheel housing. When installing, tighten starter terminals to a torque of 11 1 N m (8 1 lb ft).10. Install starter terminal (6).11. Install boot (4).12. Connect three main cables (2) to the positive (+) terminal on solenoid (3).13. Slide boot (1) on the electric starting motor terminal.14. Close the hood assembly.