GASKET 2P2720 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     6V-4876     Lubricant     -    
B     4C-9505     Gasket Sealant     -    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01164996
Install the O-ring seals, the spacer plate gasket, spacer plate (14) , and cylinder head gasket (13) . Install the spacer plate gasket with the following procedure.Note: Thoroughly clean the spacer plate, the bottom surface of the cylinder head, and the top surface of the cylinder block. A new spacer plate gasket and a cylinder head gasket must be installed when the cylinder head is removed.Note: Apply a thin film of clean engine oil on the O-ring seals prior to installation.
For best results, clean all surfaces and dry all surfaces with a solvent that is free of residue.
Apply Tooling (B) as a uniform film to the bottom side of the spacer plate gasket. Position the spacer plate gasket.
Apply Tooling (B) as a uniform film to the top side of the spacer plate gasket. Formulas that dry more slowly increase the time for the procedure.
Once the repairs are completed and the sealant has had adequate time to cure, the engine can be run.
If necessary, Tooling (B) can be removed from metal surfaces with isopropyl alcohol.
Illustration 2 g01164991
Illustration 3 g01165058
Attach a suitable lifting device to cylinder head (11) . The weight of cylinder head (11) is approximately 235 kg (518 lb).
Carefully install the cylinder head on the dowel pins on the cylinder block.Note: The bolts that are Marked "X" are 216 mm (8.5 inch) long. The remainder of the bolts are 194 mm (7.6 inch) in length.Note: Apply Tooling (A) to the bolt threads and both sides of the washers. Install cylinder head bolts (10) .
Tighten cylinder head bolts (10) according to the following procedure:
In a numerical sequence, tighten Bolts 1 through 26 to a torque of 270 15 N m (200 11 lb ft).
In a numerical sequence, tighten Bolts 1 through 26 to a torque of 450 15 N m (330 11 lb ft).
In a numerical sequence, again tighten Bolts 1 through 26 to a torque of 450 15 N m (330 11 lb ft).
Install strap (12) .
Illustration 4 g01165006
Connect hose assembly (8) and hose assemblies (9) .
Connect tube assemblies (7) .
Illustration 5 g00994660
Install O-ring seal (5) and O-ring seal (6) on seal assembly (3) .
Illustration 6 g00993714
Install adapter (4) and seal assembly (3) .
Illustration 7 g00993711
Install thrust plate (1) and bolts (2) .End By:
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".
Install the electronic unit injectors. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".
Install the rocker arms and shafts. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Install".
Install the valve mechanism cover base. Refer to Disassembly and Assembly, "Valve Mechanism Cover Base - Remove and Install".
Install the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".