GASKET 2P4305 - Caterpillar

Removal Procedure
Start By:
Remove the turbocharger, if equipped. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Remove the exhaust elbow, if equipped.
Illustration 1 g01165644
Disconnect hose assembly (2).
Disconnect hoses (3) from exhaust manifold (4).
Remove bolts (5) evenly.
Remove exhaust manifold (4) and gasket (1). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Bolt
M10 X 1.5 by 150 mm 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Improper installation of the exhaust manifold can result in a cracked exhaust manifold.
Illustration 2 g01165674
Install Tooling (A) in the cylinder head in Holes (X). Note: Do not use any sealant on the gasket.
Position gasket (1) and exhaust manifold (4) on Tooling (A). Install bolts (5) finger tight.
Remove Tooling (A). Install remaining bolts (5). Tighten the bolts evenly to a torque of 52 N m (38 lb ft).
Connect hoses (3) to exhaust manifold (4).
Connect hose assembly (2).
Install the exhaust elbow, if equipped. End By:
Install the turbocharger, if equipped. Refer to Disassembly and Assembly, "Turbocharger - Install".