GASKET-INLET 2S9476 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-9352 Engine Stand 1
B 138-7575 Link Bracket 2
C - Three Bond 1217D -
Refer to Specifications, "Crankshaft" for more information. If necessary, replace the crankshaft or recondition the crankshaft.
Ensure that the parent bores for the crankshaft bearings in the cylinder block are clean. Ensure that the threads for the bearing bolts in the cylinder block are clean and free from damage.
Clean the crankshaft bearings and the thrust washers. Inspect the bearings and the thrust washers for wear or damage. If necessary, replace the bearings and the thrust washers.Note: If the crankshaft bearings are replaced, check whether oversize bearings were previously installed. If the thrust washers are replaced, check whether oversize thrust washers were previously installed.
Ensure that all of the lubrication passages are clean and free of debris.
Illustration 1 g02861383
Install the upper thrust bearing (10) and the upper main bearings (9).Note: The upper thrust bearing (10) is installed at the Number (4) bearing cap with the oil groove facing outward.
Illustration 2 g02861360
Use a suitable lifting device to install crankshaft (8). The weight of crankshaft (8) is approximately 32 kg (70 lb).Note: Do not damage the finished surfaces on the crankshaft.
Illustration 3 g02861257
Apply clean engine oil onto bolts (4). Install bearing caps (5) and install bolts (4).Tighten bolts (4) to a torque of 142.5 4.5 N m (105.1 3.3 lb ft).
Install the lower thrust bearing (7) and the lower main bearings (6).Note: The lower thrust bearing (7) is installed at the Number (4) bearing cap with the oil groove facing outward.
Illustration 4 g02861239
Apply Tooling (C) onto the mating surface of crankcase (3). Use Tooling (B) and a suitable lifting device to install crankcase (3). Install bolts (2). Tighten bolts (2) to a torque of 52 3 N m (38.4 2.2 lb ft).
Rotate engine (1) to the upright position.
Check the crankshaft end play, side clearance, and oil clearance. Refer to Specifications, "Crankshaft" for more information.
If the crankshaft has been reground or if the crankshaft has been replaced, the height of the piston above the cylinder block must be inspected to determine the correct head gasket thickness. Refer to Specification, "Cylinder Head" and the section on Selecting the Correct Cylinder Head Gasket.
Remove engine (1) from Tooling (A).End By:
Install the pistons and connecting rods.
Install the front housing.
Install the flywheel housing.
Install the oil strainer.
Install the cylinder head