GASKET 3154667 - Caterpillar

Table 3
Temperature For The Torque Converter Stall And Implement Double Stall (1)    
Machine     Temperature    
950G Series II    
76 °C (168 °F)
to
112 °C (230 °F)    
962G Series II Fourth Gear    
76 °C (168 °F)
to
112 °C (230 °F)    
962G Series II First Gear    
76 °C (168 °F)
to
112 °C (230 °F)    
( 1 ) The temperature of the torque converter oil is measured at the torque converter outlet.
Ensure that the work tool is positioned on the ground.
Reduce the engine speed to low idle.
Fully depress the right side service brake pedal. Shift the transmission direction and speed control to the position that is referred to in Table 1. Hold the right service brake pedal in the depressed position for the duration of the test. Ensure that the parking brake is applied. Note: Do not use the left brake pedal as a service brake.Note: For the 962G II Wheel Loader, the torque converter stall test should be done with the transmission in fourth speed forward. The 962G Wheel Loader is equipped with the dual horsepower. Also, the machine must be tested for the torque converter stall in first speed forward. Note: While the parking brake is applied,the following procedure is used in order to engage the power train in the FIRST SPEED FORWARD position. Move the transmission direction and speed control to the NEUTRAL position. Select the FIRST SPEED position on the transmission direction and speed control. Move the transmission and speed control to the FORWARD position. Then move the transmission direction and speed control to the NEUTRAL position, and finally move the transmission direction and speed control back to the FORWARD position.
Illustration 2 g00892864
Instrument Panel (1) Speedometer/Tachometer module. (2) Gauge display. (3) Display for the monitoring system.
Illustration 3 g00892866
Control Panel (4) Switch for the display Module. (5) Digital Tachometer.
Press switch (4) for the display module until display shows the rpm setting. The rpm will show on the digital tachometer (5) .
To ensure that the transmission oil does not overheat, do not keep the torque converter in a full stall condition for more than 30 seconds. After the torque converter stall test, reduce the engine speed to low idle. In order to cool the oil, move the transmission control to the NEUTRAL position and run the engine between 1200 rpm and 1500 rpm.
Slowly, depress the governor control pedal to full travel. Allow the engine rpm to stabilize. Then, observe tachometer (1) or (5). Record the result. Refer to Table 2 for the correct torque converter stall speed.Note: The results of the torque converter stall test must be within specifications before the double stall test can be performed.Reference: To check the performance of the Caterpillar 3126B, refer to the following service literature: Specifications, SENR9579, "3126B Engines For Caterpillar Built Machines" and Systems Operation, Testing and Adjusting, SENR9580, "3126B Engines For Caterpillar Built Machines".The double stall test is used in order to determine the performance of the implement pump. This stall test is also used in other