GASKET 3578722 - Caterpillar

The payload system will retain the new truck ID and all the associated payload information in the onboard memory. However, this new truck will not have a description. The truck will only have an truck ID and a target weight: Note: Trucks that are entered via the Advisor are used primarily to change the weight of the "target truck" that is shown on the message center. These trucks are not in the reports that are viewed on the Advisor. The data will be displayed in the VIMS-PC reports that are generated on a computer.Operator Identification
The operator identification is usually entered into the system by the loader operator at the beginning of the shift. To enter the operator identification, perform the following:
Illustration 16 g01458206
From the Home menu, press the Down/Right button or press the Left/Up button until "Operator" is highlighted.
Press the "OK" button.
Illustration 17 g01458211
Illustration 18 g01458214
Illustration 19 g01514104
From the Operator menu, press the Down/Right button until "Select Profile" is highlighted.This will display the current operator identification: Note: The system will display "UNKNOWN" as the operator identification until an actual operator identification has been entered. Accept - Press the "OK" button in order to accept the current operator identification. New - To enter a new operator identification, enter the new number and press the "OK" button. The operator identification can be up to seven digits long. "Material Type"
The type of the material is entered at the beginning of the shift and the type of material is entered when there is a change in the type of material. Information on the material is stored when a Payload Store button is pressed. A density is associated with each type of material. The density is used with the payload weight and volume. The density is used in order to calculate an average percentage of fill factor. This average percentage is shown in the reports of VIMS-PC. To set the type of material, perform the following:
Illustration 20 g01458188
From the Home menu, press the Down/Right button until "Payload" is highlighted.
Press the "OK" button.
Illustration 21 g01458216
From the Payload menu, press the Down/Right button or press the Left/Up button until "Site Information" is highlighted.
Press the "OK" button.
Illustration 22 g01458219
From "Site Information", press the Down/Right button or press the Left/Up button until "Material Type" is highlighted.
Press the "OK" button.
Illustration 23 g01458221
Press the "OK" button.Note: The display will show a list of possible selections. The current selection may be kept by pressing the "OK" button or the current selection may be kept by entering the two digits that are displayed on the Advisor. The two digits precede new choices that are displayed on the Advisor. The initial setup contains four types of material.
From the "Material List" screen, press the Down/Right button or press the Left/Up button until the desired material is highlighted.
Press the "OK" button in order to select the material.
Table 2
ITEM     MATERIAL     DENSITY
(LB/CU.YD)    
01     OVERBURDEN     2900    
02     ROCK     3300    
03     GRAVEL     3250    
04     GRANITE     2800