GASKET 3830423 - Caterpillar

Available Updates
Note: Flashing the 232-6187 Product Link Software will reset all configuration parameters to default. Therefore, the Product Link Module will have to be configured and registered again. Record the current PLM settings prior to flashing the new 232-6187 Product Link Software .Use Caterpillar ET's Winflash application to flash the file. Re-enter the previously recorded configuration settings and re-register the Product Link Module.
Table 1
Available Updates for the 232-6187 Product Link Software    
Update     Comments    
DC R-term input allowed     The R-terminal input that signifies that the Engine Running state can now be a DC signal (an alternating square wave had previously been required). This increases flexibility for retrofitting competitive machines where alternating current is not available. Certain Caterpillar machines also provide a DC signal for Engine Running.    
Primary Wireless Type     When using ET 2002B, the Primary Wireless Type descriptions will now be Satellite Basic for a PL-151 and Satellite Premium for a PL-201. Previous versions of ET will still show Opt. #4 See Service Manual and Orbcomm for PL-151 and PL-201 respectively.