GASKET 3H5946 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite C5-A Copper Anti-Seize Lubricant -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Isolate the electric power generation set. Refer to Operation and Maintenance Manual, "Generator Isolating for Maintenance" for the correct procedure.
Illustration 1 g03705982
Disconnect harness assembly (1).
Remove engine speed/timing sensor (2) from the flywheel housing. Remove the O-ring seal from the engine speed/timing sensor. Installation Procedure
Illustration 2 g03705982
Install the O-ring seal on engine speed/timing sensor (2). Extend the sliphead of engine speed/timing sensor (2) to a minimum distance of 4.0 mm (0.16 inch) prior to installation.
Apply Tooling (A) to the threads of engine speed/timing sensor (2). Install the engine speed/timing sensor in the flywheel housing and tighten to a torque of 40 5 N m (30 4 lb ft).
Connect harness assembly (1).