GASKET 3S5453 - Caterpillar

Electric Power Generation AllIntroduction
This Special Instruction provides information about upgrading electric power generator set control mounted panels to the EMCP 4.4 control. The following is a list of the controls that can be upgraded to the EMCP 4.4:
EMCP engine status control (ESC)
EMCP1 (per 7C-1000 Control Panel Chart)
EMCP2
EMCP2+
EMCP3.1
EMCP3.2
EMCP3.3The EMCP4.4 control is intended for applications that require generator paralleling for low voltage applications less than 1000 V. Cat® floor-standing control or switch gear must be utilized for medium and high voltage applications.Proper application of EMCP4.4 paralleling controllers is critical. In various areas of this document, the document will refer to the unit as the generator set or engine. These terms are to be used interchangeably.Reference: Systems Operations Troubleshooting/Testing and Adjusting, UENR1210-01, "EMCP4.3/4.4"Reference: Application and Installation Guide, LEBE0007, "EMCP 4.3/4.4 Generator Set Control"Important Safety Information
Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Ensure that any tool, procedure, work method, or operating technique you use that is not recommended by Caterpillar is safe.Ensure that the product will not be damaged or the product will not be made unsafe by the operation, lubrication, maintenance, or repair procedures used. Proper care is your responsibility.
Do not operate or work on this engine or generator set unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals.Failure to follow the warnings and instructions could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Overview
Applicability
Illustration 1 g03705417
Enclosure dimensions
The kit is intended to replace EMCP control panels that are fitted in a generator mounted enclosure with the dimensions shown in Illustration 1. The enclosure included with the kit has three conduit holes in the bottom while some of the original controls only have two holes. The third hole can be blocked, if necessary.In addition to the control replacement, the following sensors must be replaced:
Oil pressure sensor
Engine speed sensor
Coolant temperature sensorThe sensors listed above and the needed electrical connectors are included in the upgrade kit. The EMCP 4.4 control has