GASKET-YM 4217333 - Caterpillar

Illustration 39 g00323463
Remove ring gear (76), clutch discs (77), and plate (78) from the clutch housing.
Turn the clutch housing upside-down. Remove Tooling (E). Remove the piston. Remove the ring seals from the piston and the housing.
Illustration 40 g00318689
Remove bolts (84) and the locks that hold No. 2 carrier (85) to the transfer gear case.
Illustration 41 g01305098
Install Tooling (J) and a suitable lifting device to the No. 2 carrier. The weight of the No. 2 carrier is approximately 23 kg (50 lb). Remove the No. 2 carrier.
Illustration 42 g00318693Note: There is washer (92) on the top and the bottom of gear (93).
Put the No. 2 carrier on the side. Pull shafts (89) out of the carrier. Remove gear (93) and washers (92). Remove needle bearings (90) from gear (91). Note: Use caution to prevent loss of balls (88) when shafts (89) are removed.
Remove shafts (89), gear (91) and the washers. Remove the needle bearings from gear (91). Note: Use caution to prevent the loss of the balls when shafts (86) are removed.
Remove shafts (86), gear (87) and the washers. Remove the needle bearings from the gear. Note: There is a washer on the top and the bottom of the gear.
Illustration 43 g00318697
Remove cage (94), retainer ring (96) and output shaft (95).
Illustration 44 g00318698
Remove dowel (98) from the cage. Use a Tooling (M) in order to remove dowel (98). Remove bearing (97).
Illustration 45 g00318699Note: Use caution in order to prevent the loss of ball (102) when the cage is removed.
Remove cage (99) withTooling (K). Remove bearing (100).
Inspect piston ring seals (101). If the seals are damaged or worn remove the seals and install new seals.
Remove plate assembly (103).
Illustration 46 g00318494
Remove bolts (104) and locks (105) that hold case assembly (106) to transfer gear case (107).
Remove the dowels that hold the case assembly in position on the transfer gear case. Use Tooling (L) in order to separate case assembly (106). Remove case assembly (106).
Illustration 47 g00318700
Remove bolts (108) and the lock. Remove retainer (109).
Remove the pinion from the transfer gear case.
Illustration 48 g00318497
Remove bearings (110) and the spacer with Tooling (F).
Remove the transfer gear from the transfer gear case.
Illustration 49 g00318499
Use Tooling (G) and remove bearings (112) from transfer gear (111).
Illustration 50 g00318501
Remove the plugs and dowels (114). Use Tooling (M) in order to remove the dowels.
Remove races (113).
Illustration 51 g00318563
Remove the plugs and dowels (116). Use a Tooling (M) in order to remove the dowels.
Remove races (115).