GASKET KT-YM 4374586 - Caterpillar

This is a 8.0-hour job
A maximum of $80.00 US Dollars will be allowed for materials to fabricate the four plates listed in the parts needed section.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Fabricate Plate_01, from S235 or equivalent strength structural steel. Refer to Image 1.1.1 (dimensions are in millimeter).
Image1.1.1
2. Fabricate Plate_02, from S235 or equivalent strength structural steel. Refer to Image 1.2.1 (dimensions are in millimeter). Paint the plate in order to avoid rust.
Image1.2.1
3. Fabricate Plate_03, from S235 or equivalent strength structural steel. Refer to Image 1.3.1 (dimensions are in millimeter). Paint the plate in order to avoid rust.
Image1.3.1
4. Fabricate Plate_04, from S235 or equivalent strength structural steel. Refer to Image 1.4.1 (dimensions are in millimeter).
Image1.4.1
5. Weld the Plate_01 on the Radiator Grid, as shown in Images 1.5.1, 1.5.2 and 1.5.3.
Take care to correctly position the Plate_01: the 2 holes, drilled at 30mm from Plane 02, must be on the left side of the radiator grid . Refer to Image 1.5.2.
Image1.5.1
Image1.5.2
Image1.5.3
6. Paint the Plate_01 and all the welded area.
7. Weld the Plate_04 on the SU Blade, as shown in Images 1.6.1 and 1.6.2.
Image1.6.1
Image1.6.2
8. Paint the Plate_04 and all the welded area.
9. Install the Plate_02 on the Plate_01. And assemble Plate_03, clips and grommet. Refer to Image 1.7.1.
Image1.7.1
10. Install the clips and grommet on Plate_04. Assemble the 206-2727 Guard on the 2 Tilt hoses between the Radiator grid and the Blade. Refer to Image 1.8.1.
Image1.8.1
11. Install the clips and grommet on the 2 Tilt hoses between the Blade and the Tilt cylinder. Assemble the 206-2727 Guard on these 2 Tilt hoses. Refer to Image 1.9.1.
Image1.9.1
Note: If some machines have been reworked with a Heavy Duty Radiator Grid, do not install the Plate_01. Drill 2 holes in this Heavy Duty Radiator Grid as shown in Image 1.10.1.
Install the Plate_02 on this grid. And assemble all the other components as described in this Procedure. Refer to Image 1.10.2.
Image1.10.1
Image1.10.2