GASKET-CYLINDER HEAD 4397609 - Caterpillar

Table 1
Event Code
Code and Description Conditions which Activate the Code System Response
E018(2)High Engine Oil Temperature Derate The engine oil temperature has exceeded the trip point and the delay time has expired. Engine power is derated. The code is logged.
E020 (1)High Engine Oil Temperature Warning The alarm output is activated. The code is logged. Probable Causes
Engine Oil
Engine Oil Cooler
Engine Coolant TemperatureRecommended Actions
Note: The procedures have been listed in order of probability. Complete the procedures in order.
Table 2
Troubleshooting Test Steps Values Results
1. Low Engine Oil Level
A. Check the engine oil level in the crankcase. Refer to the Operation and Maintenance Manual for calibration of the dipstick gauge. The oil level can possibly be too far below the oil pump supply tube. The oil pump cannot supply enough lubrication to the engine components.
Oil
Result: The engine oil level is low.
Add engine oil in order to obtain the correct engine oil level. Refer to Operation and Maintenance Manual, "Engine Oil" for the recommendations of engine oil.
Start the engine. Inspect the exterior of the engine for oil leaks. Repair any oil leaks.
Result: The engine oil is not low.
Proceed to Test Step 2.
2. Check the Engine for the Correct Engine Oil
A. Make sure that the engine is supplied with the correct engine oil. For the correct engine oil to use, refer to the Operation and Maintenance Manual.
Oil
Result: The engine has the correct engine oil.
Proceed to Test Step 3.
Result: The engine does not have the correct engine oil.
Replace the engine oil with the correct engine oil.
Refer to Operation and Maintenance Manual, "Engine Oil" for the recommendations of engine oil.
3. Verify the Oil Temperature
A. Check the actual engine oil temperature with a calibrated test gauge. Compare the oil temperature reading from Caterpillar Electronic Technician (ET) to the reading on the test gauge.
Oil temperature
Result: The test gauge does not match the temperature reading from Cat ET.
Replace the oil temperature sensor.
Result: The test gauge matches the temperature reading from Cat ET.
Proceed to Test Step 4.
4. Restriction in the Engine Oil Cooler Core
A. Check the engine oil cooler core for damage and for plugging.
Oil cooler
Result: The engine oil cooler is not plugged or damaged.
Proceed to Test Step 5.
Result: The engine oil cooler is plugged or damaged.
Repair or replace the engine oil cooler.
5. Engine Oil Cooler Bypass Valve
A. Inspect the components of the engine oil cooler bypass valve for damage. Ensure that the bypass valve is not stuck in the open position.
Bypass valve
Result: The engine oil cooler bypass valve is not damaged.
Proceed to Test Step 6.
Result: The engine oil cooler bypass valve is damaged.
Repair or replace the engine oil cooler bypass valve. If the symptom is corrected, return the unit to service.
6. High Engine Coolant Temperature
A. Check for high engine coolant temperatures.
Coolant temperatures
Result: The engine coolant temperatures are high.
Refer to the symptom Troubleshooting, "Coolant Temperature Is High".