GASKET 4B4590 - Caterpillar

Table 1
Parts List    
Quantity     Part Number     Description    
1     183-2047     Modulating Valve    
1 (1)     8S-0768     O-Ring Seal    
1 (2)     6D-7889     O-Ring Seal    
( 1 ) Only used on the following machines: 994 Wheel Loader, 994D Wheel Loader and 24H Motor Grader
( 2 ) Only used on the 992G Wheel Loader and 854G Wheel TractorInstallation Procedure
Illustration 1 g00785315
Transmission Lines for the 994 and 994D Wheel Loaders (Typical Example) (1) Former Valve. (2) Pump Group. (3) Torque Converter Assembly.
Locate former 121-4298 Modulating Valve (1). The former valve is located on the torque converter assembly near the pump group.
Personal injury or death can result from escaping fluid under pressure.Escaping fluid under pressure, even a very small pin-hole size leak, can penetrate body tissue and cause serious injury and possible death. If fluid is injected into your skin, it must be treated by a doctor familiar with this type of injury.Always use a board or cardboard when checking for a leak.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Remove the former valve by removing the two bolts on top of the former valve.
Install the new 183-2047 Modulating Valve. Use the bolts that were removed in Step 2. Use a 8S-0768 O-Ring Seal for the 994 and 994D Wheel Loaders and 24H Motor Grader. Use a 6D-7889 O-Ring Seal for the 992G Wheel Loader and 854G Wheel Tractor.
Refer to Service Manual module, SENR1327, "Testing and Adjusting, 992G Wheel Loader and 854G Wheel Tractor Power Train", "Torque Converter Lockup Clutch Pressure - Test" for instruction on the testing of the 183-2047 Modulating Valve on the 992G Wheel Loader and the 854G Wheel Tractor.Refer to Service Manual module, RENR2506, "Testing and Adjusting, 994D Wheel Loader Power Train", "Torque Converter Lockup Clutch Pressure - Test" for instruction on the testing of the 183-2047 Modulating Valve on the 994D Wheel Loader.Refer to Service Manual module, SENR1417, "Testing and Adjusting, 24H Motor Grader Power Train", "Torque Converter Lockup Clutch Pressure - Test" for instruction on the testing of the 183-2047 Modulating Valve on the 24H Motor Grader.
Test the operation of the machine.